New Home Foundation 101

Proverbs 3:19

The Lord put wisdom on earthly foundation

The foundation is ultimately the foundation. Before we begin building a new home, we must practice wisdom and build it right. In this article we talk about building and maintaining the foundation.

The first thing you need to know about concrete is that the most important material of the foundations is breaking it today. The foundation of the foundation does not stop, it only minimizes the cracking. They all rupture. You may not see it. Can be covered with some floor covering, but this is a crack.

Here are the elements of good basic construction:

Soil Testing – The engineering company sends a small drill to a crew to collect soil samples, usually up to 20 feet. These samples are then taken to a laboratory where they are evacuated and run through a test package to determine whether the soil is suitable for setting up the foundation. The results are given in writing to the engineer.

Design Engineer – At this point, the engineer reads the results of the soil test and determines the size, size and mode of the various parts of the base. Concrete strength is generally determined by the penny to square inches (psi) or the number of cement bags that are to be placed in a yard. Most builders use 3000psi or 4 bagged concrete. Determines the size and quality of the installed steel, the moisture barrier, the drainage of the foundation and the stairs, the floors of the garage, the slope of the porches, and so on. Required recesses etc. You can call the piers used by the foundation. The impeller should only be used if it is part of the design and should not be used expressly unless the engineer so requests. This plan will get the builder in writing.

Checking – Before placing the concrete, an inspector must visit the workplace to check that all engineer requirements have been met. Note, I said concrete was placed. If the concrete is preferred, it is too moist and too much water will put its power in danger. The builder must obtain the test report in writing before continuing.

Concrete Placement – When concrete mixers arrive, the builder must collect the documents from the truck drivers to make sure that the delivered quantity is delivered. The best way to place concrete on a large ground is a pump. Use the pump to place the concrete with the appropriate moisture content, place it reliably and do not have specific trucks. It's best if building work remains in the job, as long as this process is done to make sure it's right.

Drying – If possible, the builder must make any attempt to slow the hydration or concretion of the concrete. This reduces the amount of surface control (small cosmetic cracks) on the surface of the primer and increases the concrete cone. You can do this by spraying water after priming when it is wet and cool. Alternatively, you could cover it with wet blankets. This is usually done with bridges and some commercial structures. Once the concrete has been placed, it may be rain for rain.

Maintenance – One of the most important things a homeowner can do with maintenance is to maintain constant home moisture around their new home. If rainwater relies on one side of the home and is easy to move away from others, it requires foundation problems. Keep the drainage from the house on all sides and keep the soil wet throughout the year. Do not put the trees too close to the foundation because the roots will have a way to get moisture underneath the bottom or excessive moisture from the soil.

This is a shortened class at the foundations. To find out more, visit The Texas Residential Construction Commission to find out how to get the foundation:

http://www.trcc.state.tx.us/Consumers/state_min_warranty.asp

Copyright © 2007

Comments

(0 Comments)

Your email address will not be published. Required fields are marked *